Welch-allyn Connex VM data management system - User Manual Uživatelský manuál stáhnout pdf (Strana 15)

Transferring vital signs readings into the

system

Capture readings at the workstation

From the Connex VM workstation, you can start an NIBP measurement and capture readings from

a vital signs device. This procedure applies to wired vital signs devices that are compatible with

the system.

WARNING When you transfer data into the Connex VM system, you associate the

data with a patient by selecting a patient name in the system. Verify that you select

the correct name. If you select an incorrect name, you associate the data with a

wrong patient.

WARNING Whenever you enter data into the Connex VM workstation, verify that

the data is correct before you save it.

1. With the vital signs device connected to the Connex VM workstation, take one of these steps

from the Connex VM Home page:

• Scan or type the patient ID in the Scan or type patient ID box, and then click Go. If

you see the Patient record page, click Capture vital signs.

• Locate the patient name, and click and select Capture vital signs.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Žádné komentáře

Welch-allyn Connex VM data management system - User Manual Uživatelský manuál Strana 15