Welch Allyn SureTemp Plus REF 692 Specifikace stáhnout pdf (Strana 20)

16 Welch Allyn SureTemp Plus

TAKING A TEMPERATURE USING MONITOR MODE

1. Ensure that both the appropriately colored probe and matching probe well for the

intended measurement site (oral/axillary or rectal) are installed.

2. Holding the probe handle with your thumb and two fingers on the indentations of the

probe handle, withdraw the probe from the probe well.

3. Load a probe cover by inserting the probe into a probe cover and pressing the probe

handle down firmly. The probe handle will move slightly to engage the probe cover.

4. Take the patient’s temperature using the normal Oral, Rectal, Pediatric Axillary, or

Adult Axillary Mode as previously described.

5. Continue to hold the probe in position after the temperature is displayed.

6. Press the Mode Selection button until the Monitor Mode indicator

appears on the LCD.

7. Hold the thermometer in place for the required duration:

8. Record the temperature before removing the probe from the site.

9. Eject the probe cover by firmly pressing the ejection button on the top of the probe.

10. Replace the probe in the probe well to clear the display and reset the thermometer to

Normal Mode. The thermometer will not beep to indicate a final temperature.

Do not take a patient’s temperature without using a Welch Allyn disposable

probe cover. Doing so can cause patient discomfort, patient cross

contamination, and erroneous temperature readings.

Use only Welch Allyn probe covers. The use of other manufacturer’s probe

covers or no probe cover may produce temperature measurement errors

and/or inaccuracy.

Oral 3 minutes

Axillary 5 minutes

Rectal 3 minutes

WARNING Long-term continuous monitoring beyond three to five minutes is

not recommended in any mode.

The unit will automatically enter Monitor Mode if the probe is withdrawn

from the probe well and is not replaced within 60 seconds of inactivity.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Žádné komentáře

Welch Allyn SureTemp Plus REF 692 Specifikace Strana 20